HealthRider HRTL61706.0 Manuel d'utilisateur Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (26) so that the treadmill is more
stable.
Do not fully fold the Frame until the
treadmill is completely assembled.
Identify the Right Upright (76) which has a
RIGHT sticker. Hold the Right Upright near the
Base (81).
Insert the Upright Wire (75) into the
Right Upright until the Upright Wire is extending
from the upper end of the Right Upright. Note:
Make sure that the Upright Wire is extending
from the side of the post as shown in the inset
drawing. Remove the tie from the Upright Wire.
Thread a 2 3/4" Upright Bolt (85) and a 1" Upright
Bolt (84) with 3/8" Star Washers (83) into the
Base (81) and the bottom of the Right Upright
(76). Do not tighten the Upright Bolts yet.
6
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
d
ispose of the packing materials until assembly is completed.
Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until
assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubri-
c
ant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping
carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the
walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own phillips screwdriver .
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic
parts, do not use power tools for assembly.
26
75
76
85
84
83
81
1" Tek Screw (77)–6
3/4" Screw (23)–6
Cover Screw (52)–4
3/8" Star
Washer (83)–4
Console Screw (67)–4
Pulse Bar Star
Washer (65)–4
Silver Pulse Bar
Screw (64)–4
Endcap Screw
(79)–2
2 3/4" Upright Bolt (85)–2
5
1" Upright Bolt (84)–2
1 1/4" Bolt (63)–4
1
Wire
Post
76
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire